Bnd-50 - Se36 Instructions !!install!!

Full text of "Electronic power outlet timer BND-50 SG3 manual"

The SE36 plates fit the chassis floor pockets, directly beneath where the subframe bushings seat. Use the paper stencil or align with the four original bolt holes. bnd-50 se36 instructions

If you are integrating the BND-50 SE36 into a larger SCADA or HMI system, here are the raw communication instructions: Full text of "Electronic power outlet timer BND-50

Continue holding while pressing HOUR and MIN to set the current time of day. Programming : Programming : with a transmission jack or second

with a transmission jack or second floor jack. Remove 4 main subframe bolts (22mm).

Press the button to enter the first timer setting ("1 ON"). Set the start time using the HOUR , MIN , and WEEK buttons. Press PROG again to set the end time ("1 OFF"). Press CLOCK to save and exit the programming mode. Instructions for BND-50 Mechanical Timer